Antec Fusion with Harmony 525

[DAU0815]

Hallo,

i want to use a Harmony 525 for controlling my HTPC (Antec Fusion V2 in silver with a vfd Display). I've installed the display driver and the IMon-Manager on it but there is no reaction when pressing a remote control button. Is there a possibility to test only function of the receiver (display) for me without the original remote control? The display semms to be ok, it shows the normal informations.

Sorry for my bad english.

Regards,
DAU0815

[han_solo]

Do have another combination (Antec and 585) and its working.

1. Verify that the Remote Control is sending the signal.
2. Unplug the USB of the FrontView Module and connect again.
3. In iMon Manager select to send a signal (sound) if IR Command is detected.

Is there a signal comming in?

[DAU0815]

Hallo,

1. Remote Control is sending
2. unplugged and connected
3. Option is selected

No reaction when pressing a button (no signal in ?)

[DAU0815]

Thank you for help,

problem is solved. The receiver was 'blinded' from a piece of paper in the display. Now it's working fine.

[iMON]

Dear DAU0815 ,

Thank you for using forums. Good to see your problem is solved. since your problem is solved,
I will close this thread NOW. For some reason if you would like to open this thread please send Private message to Me, with reason for why you want to open this thread. You can send Private message by clicking 'iMON->send a private message to iMON' in the Left corner of this Post, below the Date and Time of Post. I will Open the thread for further discussion or take necessary action depending on the nature of your issue.

regards

iMON